Żywica BASF Ultracur3D Resin Cleaner - 5kg

Ultracur3D Resin Cleaner The Ultracur3D Cleaner removes any uncured photopolymer resin from printed parts and is compatible with a wide variety of resins, incl. most resins of the Ultracur3D portfolio. Cleaning Procedure 1. Immerse the part in an agitated bath of Ultracur3D Cleaner for a maximum of 10 minutes. Typical cleaning time is recommended between 5 to 8 minutes. Some require cleaning below 5 minutes. 2. Rinse with 2-propanol for additional 1-3 minutes 3. 2-propanol can be blown off with pressured air or parts can be dried at ambient temperature. For accelerated drying heat the part for approximately 10 minutes at 60 °C (140 °F)   Ultracur3D Cleaner is non-harmful, non-flammable at room temperature and can be heated up to 50 °C to increase cleaning efficiency. This cleaner is suitable for industrial part washing and cleaning equipment.   Ultracur3D® Cleaner can normally be used until it contains about 10-20% of resin, or until the cleaning performance is noticeably reduced. After this, it should be disposed according to local regulations. Material Properties Liquid Color: Blue pH value: 7 (25 °C) Melting Point: > 50 ° Boiling Point: > 100 °C Vapour Pressure: 0.017 hPa (20 °C) Density: 1.09 g/cm3 (20 °C) Viscosity @ 20 °C: mPa·s (cP) 5